Linhai ATV 500-D T3 EFI, Service Manual

Page: 206 / 291

CHAPTER 5 FINAL DRIVE
LH500ATV-D T3 EFI SERVICE MANUAL 19.0
CHAPTER 5 FINAL DRIVE. 5- 2
5.1 WH E E L , H U B , AND SPINDLE TORQUE TABLE
Item Specification
Front W
heel Nuts 69 Ft.Lbs 96 N.m
Rear W
heel Nuts 69 Ft.Lbs 96 N.m
Front Hub Nut on Spindle/ outer CV joint Refer to FRONT HUB INSTALLATION
Rear Hub Retaining Nut 101Ft.Lbs 137N.m
CAUTION
: Locking nuts, and bolts with pre-applied locking agent should be replaced if
removed. The self- locking properties of the nut or bolt are
reduced or destroyed during rem
oval.
5.2 FRONT HUB REMOVAL/INSPECTION 4x4(ATV500)
1. Elevate front end and safely support
machine under footrest/frame area.
CAUTION
Serious injury may result if machine tips
or falls. Be sure machine is secure
before beginning this service procedure.
Wear eye protection when removing
bearings and seals.
2. Check bearings for side play by grasping
tire/wheel firmly and checking for
movement. It should rotate smoothly
without binding or rough spots.
3. Remove wheel nuts and wheel.
4. Remove brake caliper
5.
Rem
ove hub cap, cotter pin, front
spindle nut,
and w
asher.
6. R
otate each bearing by hand and check for
sm
ooth rotation. Visual
l
y inspect bearing
for moisture, dirt, or corrosion. Replace
bearing
if m
oisture, dirt, corrosion, or
roughness is evident.
7. Place a shop towel on hub to protect