Linhai ATV 500-D T3 EFI, Service Manual

Page: 223 / 291

CHAPTER 5 FINAL DRIVE
LH500ATV-D T3 EFI SERVICE MANUAL 19.0
CHAPTER 5 FINAL DRIVE. 5- 19
Fig 4
5. Apply some Loctite 510 silicone sealant on
the
shaft neck of pipe joint N for the
installation .
Mount the pipe joint N on the suited hole of
the rear gear case G.
→Fig 5
Fig 5
6. Mount the shaft neck of the bevel gear
comp.-driven
E in the suited hole of the
needle bearing H.
Make the ring gear bearing housing C and
the rear gear case G together
→Fig 6
Fig 6
7. Tighten the six bolts M8×25 Q to a torque of
20~25N.m .
Tighten the two bolts M10×1.25×25 P to a
torque of 35~40N.m .
Tighten the HE× screw T
，
the gasket| S and
the nut M8 R to a torque of 20~25N.m .
→Fig 7
Fig 7