Linhai ATV 500-D T3 EFI, Service Manual

Page: 219 / 291

CHAPTER 5 FINAL DRIVE
LH500ATV-D T3 EFI SERVICE MANUAL 19.0
CHAPTER 5 FINAL DRIVE. 5- 15
5-3 ADJUST SHIM(2) 0.4 28 WASHER 14
6 RING GEAR BEARING HOUSING 30 NEEDLE BEARING 55BTM6720A
7 BOLT M8×25 31 OIL SEAL 65×90×9
8 BOLT M10×1.25×25 32 WIRE CLAMP A7
9 BOLT M8×35 33 NUT M8
10 INNER & OUTER RACE 34-1 ADJUST SHIM(0.40)
11 BEVEL GEAR COMP. REAR AXLE 34-2 ADJUST SHIM(0.50)
12 ADJUST SHIM 34-3 ADJUST SHIM(0.60)
13 BEARING 16017/C2 35 REAR GEAR BEARING HOUSING
14 BEARING RETAINER 36 BEARING 16017/C2
15 BEVEL GEAR BEARING HOUSING 37 O-RING 151×3
16 OIL SEAL Φ35×Φ61×9 38 OIL SEAL 65×90×9
17 WASHER 12.5×30×4 39 GASKET 8.2×15×1.5
18 NUT M12×1.25 40 HEX SCREW M8×45
5.6 REAR GEAR CASE DISASSEMBLY
Important: Before staring any operation
On the gearbox
，
make sure that never clean
the gearbox with a high pressure water jet .
1. Remove the oil drain plug A and let the oil
drain from the gearbox .
Important: Clean the plug carefully .
Replace the sealing washer B before it’s
assembled . →Fig 1
Fig 1
2. Remove the nut M12×1.25 C
，
the washer
12.5×30×4 D and the coupler of the rear
axle E.
→Fig 2