Linhai ATV 500-D T3 EFI, Service Manual

Page: 24 / 291

CHAPTER 2 MAINTENANCE
LH500ATV-D T3 EFI SERVICE MANUA 19.0
CHAPTER 2 MAINTENANCE PAGE. 2- 11
bolts). Use designated bolts only.
Follow the tightening torque and tightening
sequence instruction. Over torque and
miss-sequence can cause unequal
compression of gasket and leakage.
Install the fuel tank to vehicle.
Connect for fuel hoses with suitable hose
clamps.
Connect fuel module coupler
Follow “Fuel Leakage Check Procedure’ to
check any leakage before the engine is
started.
Fuel Pressure Relief Procedure:
Caution: This work must not be done when
engine is hot. If done so, it may cause
adverse effect to catalyst (if equipped)
After making sure that engine is cold, relieve
fuel pressure as follows.
Place vehicle gear in ‘Neutral’.
Disconnect fuel module electrical coupler from
vehicle harness.
Start engine and run till it stops due to lack of
fuel. Repeat ignition key ON and OFF
for 2 ~ 3 times of about 3 seconds each time to
relieve fuel pressure in lines. Fuel
Connections are now safe for servicing.
Upon the completion of servicing, Connect Fuel
Module Connector to Vehicle Harness
2.3 TOE ALIGNMENT
METHOD: STRAIGHTEDGE OR STRING
Be sure to keep handlebars centered
NOTE: String should just touch side surface
of rear tire on each side of the ATV.
Measure from string to rim at front and rear of
rim.
Rear rim measurement (A) should be 1/16" to
1/8" (1.5 to 3 mm) more than front rim
measurement (B).
NOTE: The steering post arm (frog) can be
used as an indicator of whether the
handlebars are straight. The frog should
always point straight back from the steering
post when handlebars are straight.
WARNING: Always pay attention to tie rods
assembly, Both ends must screw in same
and enough threads length.