67
Leica ST5020
1. Select the station carrying the unknown clip - the station is displayed
as having been pressed (wider border) - as e.g. station
L34
in (
Fig. 60
).
2. Press the color button corresponding to the actual color of the clip
on the rack. The color selected will be displayed on the station button
(here:
L34
).
3. Press
CONFIRM
to go back to
INSTRUMENT STATUS
. The color will
be allocated to the station (clip) as selected. If the selected color was
already allocated to a different program, the 3-digit program code of
that program will be shown as well (see also
Creating programs
chap-
ter 5.6.1
). Otherwise, three question marks "
???
" will be displayed in-
stead of a program code.
If the clip color 'white' is selected, the instrument will switch to
MANUAL PROGRAM START, where any program can be selected
and started (see
chapter 5.8.2
).
5.6.3 Assigning a clip color
Fig. 63
Every time the load drawer is closed, the loading
area is scanned for transponder signals coming
from the clips attached to the racks in that area.
• In supervisor mode, the instrument automati
-
cally switches from
INSTRUMENT STATUS
to
CLIP COLOR
if an unknown clip code is de-
tected on a rack.
• If in user mode, a message is displayed tell
-
ing the user that supervisor mode is required
and asking whether to switch to that mode
(see
chapter 5.8.2
).
If an unknown clip is detected, proceed as fol-
lows:
Automatic start
5. Operation
→
In this menu, you tell the instrument what color the clips attached to the individual racks are.
You need to be in supervisor mode to assign colors to clips.
