Kyocera Mita DC-2060, Service Manual

Page: 330 / 437

3-3-115
1AH
( 3 ) Adjusting the position of the width size changing knob
Perform the following adjustment if there is a regular error between the centers of the
original and the copy image on the paper feed from a cassette.
Caution: Before starting this adjustment, ensure ( 4 ) Adjusting the position of the
original size indicator (see page 3-3-15) has been completed.
Procedure
Figure 3-3-112
Figure 3-3-113
Original Copy example 1 Copy example 2
Yes
No
Start
End
Make a test copy with same size.
Loosen the three screws holding
the width size changing knob and
adjust the position of the width
size changing knob.
• For example 1, move it toward
the machine front ( ).
• For example 2, move it toward
the machine rear ( ).
Is the center of the
image aligned with that
of the original?
e
b
Screws Width size changing knob