Kyocera Mita DC-2060, Service Manual

Page: 328 / 437

3-3-113
1AH
( 2 ) Detaching and refitting the paper width switch (For inch models only.)
Check or replace the paper width switch as follows.
Caution: After replacing a paper width switch, be sure to perform ( 3 ) Adjusting the
position of the width size changing knob. (see page 3-3-115)
Procedure
1. Take the cassette out of the copier. (see page 3-3-108)
2. Remove the two screws and 8-pin socket from the rear of the cassette.
3. Remove the 8-pin paper width switch connector from the 8-pin socket.
* When refitting the 8-pin socket, keep the convex part toward upper.
4. Remove the three screws holding the width size changing knob.
5. While lifting the cassette lift in the direction of the arrow, remove the width size
changing knob.
Cassette lift
Width size
changing knob
Screws
8-pin socket
Convex
8-pin paper width
switch connector
Screws
Figure 3-3-109