Kyocera Mita DC-2060, Service Manual

Page: 255 / 437

3-3-46
1AH
7. Attach the scanner wire of the machine front to the each pulley with the following
procedure.
1 Run the scanner wire with the round terminal along the groove in the inner
scanner (machine rear) pulley on light source unit 2, from bottom to top.
2 Fit the round terminal of the Step 1 to the pressure adjuster at the right side of
the machine.
3 Run the scanner wire with the ball along the groove in the scanner pulley of the
machine from bottom to top.
4 Run the scanner wire with the ball of the Step 3 along the groove in the outer
scanner (machine front) pulley on light source unit 2, from bottom to top.
5
Hook the ball of the Step
4
onto the tension spring at the left side of the
machine.
Pressure adjuster
Scanner wire drum
Machine front
Scanner wire
Round terminal
Scanner pulley on
light source unit 2
Ball
Tension spring
Scanner pulley
of the machine
2
3
4
1
5
Figure 3-3-55