Konica Minolta bizhub 601, User Manual

Page: 442 / 538

751/601 11-46
Utility mode 11
The System Settings screen appears.
3
Touch [7 Expert Adjustment].
The Expert Adjustment screen appears.
4
Touch [5 Finisher Adjustment].
The Finisher Adjustment screen appears.
5
Touch [5 Punch Horizontal Position Adjustment].
The Punch Horizontal Position Adjustment screen appears.
6
Check the horizontal position of the punched holes.
– To increase width A, touch [+] to increase the adjustment (between 0.1 mm and 5.0 mm).
– Each time [+] or [-] is touched, the value is increased or decreased by one increment.
– To decrease width A, touch [-] to decrease the adjustment (between -0.1 mm and -5.0 mm).
7
Touch [OK].
– To cancel the setting and select the default, press the [Reset] key.
The horizontal position of the punched holes is adjusted.
If no adjustment of the horizontal position of the punched holes was necessary in step 6, this completes
the procedure.
A
A