Konica Minolta bizhub 601, User Manual

Page: 438 / 538

751/601 11-42
Utility mode 11
– If the folding position is too far to the right of the center of the paper, touch [-] to reduce the
adjustment (between -0.1 mm and -12.8 mm).
8
Touch [OK].
– To cancel the setting and select the default, press the [Reset] key.
The center folding position is adjusted.
If the folding position was at the center of the paper in step 7, this completes the procedure.
9
Use the "Half-Fold" setting to print another sample copy.
10
Check the print result.
– Check that the folding position is adjusted to the center of the paper.
– If more adjustment is necessary, repeat steps 6 through 9.
2
Note
Set the value by mm. Refer to the conversion rate below.
1 inch = 25.4 mm
11.6.3 Punch Vertical Position Adjustment
The vertical position of punched holes when printing with a Punch setting can be adjusted for each paper
size.
2
Note
[Punch Vertical Position Adjustment] appears only if optional punch kit is installed on the finisher.
For details on the Punch settings, refer to "Punching holes in copies (Punch settings)" on page 2-62 .
0 Before making any adjustments, use a Punch setting to print a sample copy. Perform the adjustment
while checking the sample that was created.
1
Display the Administrator Settings screen.
– For details on displaying the Administrator Settings screen, refer to
"Displaying the Administrator
Settings screen" on page 11-36 .
2
Touch [1 System Settings].
The System Settings screen appears.
3
Touch [7 Expert Adjustment].
The Expert Adjustment screen appears.
4
Touch [5 Finisher Adjustment].
The Finisher Adjustment screen appears.
5
Touch [3 Punch Vertical Position Adjustment].