Konica Minolta bizhub 601, User Manual

Page: 419 / 538

751/601 11-23
Utility mode 11
11.4 Specifying administrator settings
This section describes the function and main registration parameters that can be specified after pressing the
[Utility/Counter] key, then touching [Administrator Settings].
11.4.1 System Settings
Power Save Settings
Output Settings
Date/Time Settings
Daylight Saving Time
Parameter Description Default Setting
Low Power Mode Set-
tings Specify the desired length of time (between 1 and 240 min-
utes) until the machine enters Power Save mode. 15 minutes
Sleep Mode Settings Specify the desired length of time (between 1 and 240 min-
utes) until the machine enters Sleep mode. 60 minutes
Power Save Key Select which low power mode is entered when the [Power
Save] key is pressed.
•
Low Power:
The touch panel goes off and the machine enters a mode
where it conserves energy.
• Sleep:
Although the machine conserves more energy in Sleep
mode than in Power Save mode, the machine must warm
up when Sleep mode is canceled, therefore taking more
preparation time than Power Save mode.
Low Power
Enter Power Save
Mode Specify settings for faxing. For details, refer to the User’s
Guide [Network Scan/Fax/Network Fax Operations]. Normal
Parameter Description Default Setting
Print/Fax Output
Setting Specify settings for faxing and printing. For details, refer to the Us-
er’s Guide [Network Scan/Fax/Network Fax Operations] and the Us-
er’s Guide [Print Operations].
Output Tray Set-
tings Select the finishing tray for each type of job (copies, printouts, re-
ports and faxes). Copy: Tray 1
Printer: Tray 1
Print Reports: Tray 2
Fax: Tray 2
Shift Output Each
Job Select whether or not printed copies are fed out shifted when "Off-
set" is selected while a finisher is installed.
•
Yes: Pages are fed out shifted.
• No: Pages are fed out without being shifted.
Yes
Description Default Setting
Specify the current date and time. In addition, the time zone can be set between -12:00
and 13:00 (in 30-minute increments). Time Zone: +00:00
Description Default Setting
Select whether or not the machine’s internal clock observes daylight saving time. If
"Yes" is selected, a setting appears so that the length of time for adjusting the current
time can be set. The length of time applied for daylight saving time can be set between
1 and 150 minutes in 1-minute increments. No