81
⑸
When the measurements are completed, or
when STOP is pressed after the measurement
values are displayed during repeat measurement.
·
When ANG has been selected, the distance can
not be displayed.
·
If adopt the result, enter the target height of the
first known point and press YES. Then go to
observe next known point.
·
Discard the result, press NO.
YES
Or NO
Resection Point: 1
S 6.979 m
ZA 99°31′28″
HAR 67°11′15″
Tgt. h
：
1.500 m
NO YES
⑹
Repeat steps 4 to 5 in the same way from the
second point. When the minimum quantity of
observation data required for the calculation is
present, CALC is displayed.
Press F1 CALC to automatically start
calculations after observations of all known
points are completed.
·
Re-measure the point: NO
·
Measure next point: YES
·
Calculate occupied station: CALC
CALC
(or YES
Or NO)
Resection
N 2705018.561 m 3
E 585502.155 m
Z 3.254 m
Sight Pt. 2
ANG. DIST
Resection Pt. 2
S 13.901 m
ZA 94°32′45″
HAR 32°56′31″
Tgt. H
：
1.500 m
CALC NO YES
⑺
When dHD, dZ are close to 0, it means the
result is precise, press F4 OK
If you don’t need Elevation value, no need to care
about dZ value.
ROBS: remeasure the known points.
ADD: add a new known point
REC: accept the result and record it.
OK
N 2705006.931
E 585494.619
Z 4.326
dHD 0000 mm
dZ 0000 mm
ROBS ADD REC OK
⑻
Follow the screen notice and sight at the
known point, press F4 to set bearing angle.
Station Point is set.
Resection
Please sight at the 2nd point
Set bearing angle
HAR 32°56′27″
NO YES
·
Abandon the results and stop measuring: ESC
·
Abandon the results and re-measure: RE_OBS (See 15.1 Re-observing”)
·
Abandon the results and add known points: ADD
·
Adopt the results and record in JOB: REC (Refer to“21.4 Recording Distance Measurement Data”)
(To set direction angle press OK, otherwise press ESC)
