46
PROCEDURE
Operating Procedure
Operation
Display
⑴
In MEAS mode, display the screen in which
DOUT is registered, press DOUT, following
screen is displayed.
DOUT
DOUT
1. Dist data
2. Angle data
⑵
Use ▲▼ to select “1. Dist data,” and press
ENT (or numeric key 1) to start distance
measuring. Then distance mode, prism constant
correction value, atmospheric correction factor
，
distance measurement method are represented by
a flashing display.
Select “1.
Dist data”
+
ENT
Dist
.
Dist PC = -30
PPM = 0
Fine[s]
STOP
⑶
When distance measurement is completed, a
short beep sounds, and the measured distance
data(s), vertical angle (ZA), and horizontal
angle (HAR) are displayed. Then the
measured data begins being out put. When
repeat fine mode is selected, press STOP key
to stop the output.
Dist
.
PC -30
PPM 0
S 1234.569 m 3
ZA 89°59′54″
HAR 117°31′50″ P1
STOP
NOTE:
When “2.Angle data” is selected in step 2, the angle data which is displayed on the screen can be output.
