KGP-920
Chapter 8
Setup Procedure
93121662-00
8-9
(17) Press [ ] or [ ] key to set bit rate.
(18) Press [
ENT
] key .
(19) Press [ ] key to move cursor to the station name (STN NAME) field.
(20) Press [ ] [ ] [ ] [ ] key to select a comment letter or symbol from the comment letter
table by locating cursor on it, or enter a value using numeric keys.
(21) Press [
SEL
] key . And one letter or symbol are made to decide.
(22) You can enter up to 10 letters by repeating (20) and (21) steps.
(23) Press [ENT] key and decide of a station name.
8.3.7 Selecting the DGPS input signal baud rate
(External beacon receiver system only)
Initial setup: 4800 bps
Adjust the baud rate of RTCM SC-104 format signal reception to the output signal baud rate of beacon
receiver.
(1) Press [
MENU
] key until Menu options 1 to 9 appears.
(2) Press [
4
] key to select “
4:DGPS
”.
(3) Press [ ] or [ ] key to move cursor onto “
NEXT
” and 2/2 page is displayed.
(4) Press [
4
] key to select “
4:BAUD RATE
”.
(5) Press [ ] or [ ] key to move cursor onto the correct baud rate.
(6) Press [
ENT
] key.
8.3.8 DGPS monitor
(Beacon DGPS only)
DGPS monitor provides information on the DGPS beacon receiver interface and receiving status.
(1) Press [
MENU
] key until Menu options 1 to 9 appears.
(2) Press [
4
] key to select “
4:DGPS
”.
(3) Press [ ] or [ ] key to move cursor onto “
NEXT
” and 2/2 page is displayed.
Cursor
Baud rate
Bit rate
Table of comment
Letters and symbols
Station name field
Station name
Frequency
Bit rate
