KIP 7170K, Service Manual

Page: 705 / 865

K134sm8e6 8-146
8. 4. 3. 111 Target Density (No.653)
It is possible to change Target Density that should be achieved and maintained for consistent print
density.
If the current density does not meet Target Density, Regulation (Developer) Bias will be
automatically adjusted based on the current Adjustment Level.
• If the current Density Value is judged “not enough” (lighter than required), the next level will be
applied.
• If the current Density Value is judged “adequate”, the current level remains.
• There is possibility for the Density Value to be judged “too much enough” (darker than
required), then the previous level will be applied.
If you increase the setting value by “+1”, Target Density will rise and thus Auto Adjustment Level
would be switched to the next level earlier.
Default Value Setting Range Step of increment
135 110 to 150 1
8. 4. 3. 112 Regulation Bias Maximum (No.654)
It is possible to change the maximum of Regulation Bias.
When the total value amount of Regulation Bias (No.622) and Total Increment of Regulation Bias
Adjustment (No.641) reaches to the value of this setting, Regulation Bias cannot raise any more.
If you increase the setting value by “+1”, the maximum of Regulation Bias increases.
Default Value Setting Range Step of increment
293 0 to 1023 1
NOTE
This setting has been factory-adjusted. Keep the value unchanged.
NOTE
This setting has been factory-adjusted. Keep the value unchanged.