KIP 7170K, Service Manual

Page: 16 / 865

K134sm1e1 1-14
Paper that has already been
used for printing
Extremely sticky
Extremely thin and soft
Extremely slippery
OHP Film
1. 5. 2 Keeping the paper in the custody
Keep the paper in the custody taking care of the following matters.
1. Do not expose the paper to the direct sunlight.
2. Keep the paper away from high humidity. (It must be less than 70%)
3. Put the paper on a flat place
4. If you will keep the paper in the custody, which you have already unpacked, put it into the
polyethylene bag to avoid the humidity.
CAUTION
Do not use the paper with staple, or do not use such conductive paper as aluminium foil and
carbon paper.
Such paper may become cause for the fire.
NOTE
(1) Print image may become light if printed on a paper of rough surface.
(2) Print image may become defective if the print paper is much curled.
(3) It will become a cause for paper mis-feed, defective print image or crease of paper if you
use a paper that does not satisfy the specification.
(4) Do not use a paper of which surface is very special, such as thermal paper, art paper,
aluminium foil, carbon paper and conductive paper.
(5) Do not use papers with unpacked (exposed in high / low temperature & humidity) in a
long period. Such papers may result in mis-feed, defective image or paper creasing.
(6) Tracing paper exposed to air over a long period tends to defective printing.
Removing one round on the surface of the tracing roll paper from the beginning is
recommended.
(7) Initial cut for the leading edge before making a long print is recommended.