KIP 7170K, Service Manual

Page: 488 / 865

Step #1 - Prepare Machine

Ask User on Printer Performance / Image Quality

Run Test Print

Locate the “KIP 7170K PM Schedule” Form
Check off each item completed
Replace noted items as this procedure progresses

Remove Drum
(into Box)

Remove side and top covers
Step #2 - Corona Units

Clean Grid Screen
(Simple Green, then rinse with water and let dry on paper towel)

Clean 1
st
Charge wires and case
(Glass cleaner)

Clean transfer / separation wires and case
(Glass cleaner)
Step #3 - LED Print Head

Clean LED lens
(Glass cleaner)
Step #4 - Clean Interior of Printer

Separation fans / air guides

Transport belts

Transfer guide plates etc.
Step #5 - Development Unit

Clean spacing rollers

Vacuum any toner dust from ends of developer unit

Vacuum around toner hopper inlet

Clean / lube gears
(only as needed with G501 grease / Lithium grease - see Chapter 6 in
Service Manual)
Step #6 - Paper Decks

Vacuum paper dust

Inspect media collars
Step #7 - Air Flow

Vacuum Ozone Filters

Confirm all fans and blowers are clean
Step #8 - Fuser Section

Clean upper Nails

Clean lower Nails

Clean and lube gears
(as needed with High temp. grease - see Chapter 6 in Service Manual)
Step #9 - Cutter Assembly

Clean paper dust
Step #10 - Run test pattern #1 and #3 and verify print quality (save prints)
Step #11 - Scanner

Remove glass and clean both sides

Clean original rollers
Step #12 - Clean Panels and Covers
Step #13 - Make copies / prints
Step #14 - Speak with key operator on your evaluation / status
r1
KIP 7170K
Preventative Maintenance
Performed every 50,000 sq ft or
6000 linear meters