Keysight P9241, Scpi Programmer'S Manual

Page: 771 / 1344

:SBUS<n> Commands
25
Keysight P9241/42/43A Oscilloscopes SCPI Programmer's Guide 771
:SBUS<n>:UART:TRIGger:TYPE
(see page 1196 )
Command Syntax
:SBUS<n>:UART:TRIGger:TYPE <value>
<value> ::= {RSTArt | RSTOp | RDATa | RD1 | RD0 | RDX | PARityerror
| TSTArt | TSTOp | TDATa | TD1 | TD0 | TDX}
The :SBUS<n>:UART:TRIGger:TYPE command selects the UART trigger type.
When one of the RD or TD types is selected, the :SBUS<n>:UART:TRIGger:DATA
and :SBUS<n>:UART:TRIGger:QUALifier commands are used to specify the data
value and comparison operator.
The RD1, RD0, RDX, TD1, TD0, and TDX types (for triggering on data and alert bit
values) are only valid when a 9-bit width has been selected.
Query Syntax
:SBUS<n>:UART:TRIGger:TYPE?
The :SBUS<n>:UART:TRIGger:TYPE? query returns the current UART trigger data
value.
Return Format
<value><NL>
<value> ::= {RSTA | RSTO | RDAT | RD1 | RD0 | RDX | PAR | TSTA |
TSTO | TDAT | TD1 | TD0 | TDX}
See Also • "Introduction to :TRIGger Commands" on page 901
• ":TRIGger:MODE" on page 914
• ":SBUS<n>:UART:TRIGger:DATA" on page 768
• ":SBUS<n>:UART:TRIGger:QUALifier" on page 770
• ":SBUS<n>:UART:WIDTh" on page 772