Keysight P9241, Scpi Programmer'S Manual

Page: 542 / 1344

542 Keysight P9241/42/43A Oscilloscopes SCPI Programmer's Guide
23
:RECall Commands
:RECall:WMEMory<r>[:STARt]
(see page 1196 )
Command Syntax
:RECall:WMEMory<r>[:STARt] [<file_name> | <data>]
<r> ::= 1 to (# ref waveforms) in NR1 format
<file_name> ::= quoted ASCII string
<data> ::= binary block data in IEEE 488.2 # format
The :RECall:WMEMory<r>[:STARt] command recalls a reference waveform.
The <data> option lets you recall a reference waveform from a local file on the
controller PC (instead of from a USB storage device connected to the
oscilloscope). In this case, your remote program reads data from the local ".h5"
format reference waveform file in the same way that setup files are restored to the
oscilloscope (see ":SYSTem:SETup" on page 883).
See Also • "Introduction to :RECall Commands" on page 534
• ":RECall:FILename" on page 537
• ":SAVE:WMEMory[:STARt]" on page 571
NOTE
If a file extension is provided as part of a specified <file_name>, it must be ".h5".