Keysight Technologies N6900 Series, Operating And Service Manual

Page: 31 / 358

:FUNCtion
:CURRent 0|OFF|1|ON Enables/disables current data logging.
:MINMax 0|OFF|1|ON Enables/disables min/max current data logging.
:VOLTage 0|OFF|1|ON Enables/disables voltage data logging.
:MINMax 0|OFF|1|ON Enables/disables min/max voltage data logging.
:PERiod < value > Sets the integration time of an Elog measurement.
:FAULt
:STATe 0|OFF|1|ON Enables or disables remote sense fault detection.
:SWEep
:NPLCycles < value > Sets the measurement time in number of power line cycles.
:OFFSet
:POINts < value > Defines the offset in a data sweep for triggered meas-
urements.
:POINts < value > Defines the number of points in a measurement.
:TINTerval < value > Defines the time period between measurement samples.
:THReshold<1|2|3|4>
:AHOur
[:LEVel] < value > Sets the amp-hour level for comparator 1,2,3, or 4.
:CURRent
[:LEVel] < value > Sets the current level for comparator 1,2,3, or 4.
:FUNCtion
VOLT|CURR|POW|AHO|WHO Sets the sensing function for comparator 1,2,3, or 4.
:OPERation GT|LT Sets the comparison type for comparator 1,2,3, or 4.
:POWer
[:LEVel] < value > Sets the power level for comparator 1,2,3, or 4.
:VOLTage
[:LEVel] < value > Sets the voltage level for comparator 1,2,3, or 4.
:WHOur
[:LEVel] < value > Sets the watt-hour level for comparator 1,2,3, or 4.
:WHOur
:RESet Resets the accumulated watt-hour measurement.
:WINDow
[:TYPE] HANNing|RECTangular Selects the measurement window.
[SOURce:]ARB Subsystem
[SOURce:]
ARB
:COUNt < value >|INFinity Specifies the number of times the Arb repeats.
:CURRent
:CDWell
[:LEVel] < value >{,< value >}| <Block> Specifies the level of each point in the Arb.
:DWELl < value > Specifies the dwell time of each point in the Arb.
:POINts? Returns the number of points in the Arb.
:FUNCtion
Keysight N6900/N7900 Series Operating and Service Guide 31
1 Quick Reference