Keysight Technologies N6900 Series, Operating And Service Manual

Page: 211 / 358

ARB Subsystem
ARB commands program the constant-dwell arbitrary waveforms. Constant-dwell waveforms can
have up to 65,535 points assigned to them, with the same dwell time for each point.
[SOURce:]
ARB
:COUNt < value >|INFinity Specifies the number of times the Arb repeats.
:CURRent
:CDWell
[:LEVel] < value >{,< value >}| <Block> Specifies the level of each point in the Arb.
:DWELl < value > Specifies the dwell time of each point in the Arb.
:POINts? Returns the number of points in the Arb.
:FUNCtion
:TYPE CURRent|VOLTage Specifies either a voltage or current Arb.
:TERMinate
:LAST 0|OFF|1|ON Selects the output setting after the Arb ends.
:VOLTage
:CDWell
[:LEVel] < value >{,< value >}| <Block> Specifies the level of each point in the Arb.
:DWELl < value > Specifies the dwell time of each point in the Arb.
:POINts? Returns the number of points in the Arb.
[SOURce:]ARB:COUNt < value >|MIN|MAX|INFinity
[SOURce:]ARB:COUNt? [MIN|MAX]
Specifies the number of times the Arb repeats. Use the INFinity parameter to repeat the Arb
continuously.
Parameter Typical Return
1 – 256, *RST 1 <count>
Programs a repeat count of 10: ARB:COUN 10
[SOURce:]ARB:CURRent:CDWell[:LEVel] < value >{,< value >}|< Block >
[SOURce:]ARB:CURRent:CDWell[:LEVel]?
[SOURce:]ARB:VOLTage:CDWell[:LEVel] <
value >{,< value >}|< Block >
[SOURce:]ARB:VOLTage:CDWell[:LEVel]?
Specifies the level of each point in the Arb. Values are specified in either amperes or volts. The
minimum and maximum values depend on the ratings of the unit.
6 SCPI Programming Reference
211 Keysight N6900/N7900 Series Operating and Service Guide