Keysight Technologies N6900 Series, Operating And Service Manual

Page: 298 / 358

206 File not found
The internal calibration file or the internal channel attribute file was not found in NVRAM.
207 Cal file version error
The calibration file was written or read using old firmware. Firmware must be updated.
208 Running backup firmware
The instrument is presently running the backup (previous) version of the firmware.
210 Frame NVRAM error
A non-volatile RAM error has occurred in the instrument.
212 State file not loaded
A previously saved output state file has failed to load.
213 Sinkbox error
A cable has disconnected or a hardware error has occurred on the power dissipator.
214 Line frequency error
A discrepancy has occurred between the line frequency and the line frequency setting.
215 Hardware failure
A hardware failure has occurred on the power supply or the power dissipator
302 Option not installed
The option that is programmed by this command is not installed.
303 There is not a valid acquisition to fetch from
There is no valid data in the measurement buffer.
304 Volt and curr in incompatible transient modes
Voltage and current cannot be in Step and List mode at the same time.
305 A triggered value is on a different range
A triggered value is on a different range than the one that is presently set.
306 Too many list points
Too many list points have been specified.
307 List lengths are not equivalent
One or more lists are not the same length.
308 This setting cannot be changed while transient trigger is initiated
Setting cannot be changed while the instrument is waiting for or executing a trigger sequence.
Keysight N6900/N7900 Series Operating and Service Guide 298
6 SCPI Programming Reference