KaVo ORTHOPANTOMOGAPH OP 2D, Service Manual

Page: 101 / 128

5. S2terminal and service commands
ORTHOPANTOMOGAPH OP 2D 91
setserno con fi gure serial number (and MAC accordingly)
To display the CURRENT setting key in
____________________________________________
> serno => the current serial number appears
____________________________________________
and then press Enter .
To change the serial number, e.g. if you change the
CPU board key in
____________________________________________
> setserno IOXXXXXXX
( new serial number )
____________________________________________
and then press Enter .
stillmode still image exposure
Generates x-rays and activates the CCD sensor but the
rotating unit does not move.
It is used to check the beam alignment during unit
installation (refer to the Installation manual for more
information).
CAUTION:
Protect yourself from radiation when carrying out
this procedure.
Press and hold the exposure switch to take a still image
exposure.
NOTICE!
The " exp " command, described earlier, generates x-
rays but does not activate the sensor or move the rotat-
ing unit.
warmup tubehead warmup before fi rst use
Initializes the tubehead. Must be used when the unit is
installed or if the unit has not been used for a long time.
CAUTION:
Protect yourself from radiation when carrying out
this procedure.
Press and hold the exposure switch until the procedure
is complete. The procedure may take some minutes.