KaVo ORTHOPANTOMOGAPH OP 2D, Service Manual

Page: 99 / 128

5. S2terminal and service commands
ORTHOPANTOMOGAPH OP 2D 89
mainscalib calibrates mains voltage
parameters: <current voltage>
Recalibrates the mains voltage if L1200 CPU board is
replaced.
Use a RMS multimeter to measure the actual supply
voltage (from the supply outlet used for the unit power
feed) and then enter this value.
____________________________________________
>mainscalib xxx
(xxx is the value read from multimeter)
____________________________________________
and then press Enter .
mainsprint print current mains voltage value
Displays the current line voltage value as measured by
the unit.
Useful for debugging when the unit displays error E5.
motortest run exposure ramp
A test drive for the rotation motor. The test checks that
motor is driven to the correct angle and that it works as
speci fi ed.
optotest prints optosensor values for 30 seconds
Allows L2100 to be checked. Optosensors on L2100
monitor the position of the rotating unit.
The "optotest" command displays, for 30 seconds, val-
ues that indicate the position of the L2100 board. When
you manually rotate the rotating unit the values should
change,
____________________________________________
sector 0
sector 1
sector 2
sector 3
____________________________________________
which indicates that the optosensors on the L2100
board are working and that the board is functioning cor-
rectly.
If the values do not change, the L2100 board or the
cabling is faulty.