K&R GT600-4T132G, User Manual

Page: 28 / 362

2. Mechanical Installation
- 26 -
Mounting Method Applicable Housing Remark
Backplate
mounting Plastic housing
Sheet metal housing
The AC drive is mounted directly on the backplate of
the cabinet . It is secured using four screws or bolts at
the corners of the backplate.
Through hole
mounting Plastic housing
Sheet metal housing
It requires a cut-out in the backplate. The housing
must be secured in place by using the through-hole
mounting bracket and then be lifted into the cut-out.
2
It is very important that you identify correct mounting hole locations and diameters
of the drive you are installing. And check that you have identified correct dimensions
before you start to drill the mounting holes.
2.4 Installation Method and Procedures
■
Installation Method
CAUTION
The drives of GT600-4T200G to GT600-4T400G support mounting in cabinet only.
Mounting Method Applicable Model Remark
Mounting in
cabinet GT600-4T200G(-L)
to GT600-4T400G(-
L) It requires installation of fixing beam, bottom mounting
bracket and guide rail first. The AC drive can be then
pushed into the cabinet and secured.
2.4.1 Backplate Mounting
The backplate mounting process is as follows:
1. Select a suitable location. See recommendations in .
CAUTION
2. Measure and mark the drilling centers for the four mounting holes according to the
dimensions shown in GT600 for your model of the drive.
3. Carefully drill the four mounting holes at the correct diameter as shown in
model of the drive.
for your
4. If necessary, lift the drive to the installation location. Hold it in correct position until there are
fixings in place to secure it safely.
5. Add locking washers and flat washers to the securing bolts or screws, insert them through
the four mounting holes in the housing, and tighten them to secure the housing to the
backplate.
Note
Check that there are no items of equipment, cables or pipes behind mounting
surface that might be damaged when you drill mounting holes.
The drive units enclosed in a sheet-metal housing have weights of 35 kg or more.
These units have eye bolts that allow a mechanical hoist to support the weight of
the unit during installation. To prevent personal injury or damage to the equipment,
you must fit and use these eye bolts to support the drive during installation.