Juniper OCX1100, Hardware Manual

Page: 67 / 204

CHAPTER 7
Transceiver and Cable Specifications
• Pluggable Transceivers Supported on OCX1100 Switches on page 47
• SFP+ Direct Attach Cables for OCX1100 Switches on page 50
•
Management Cable Specifications on page 53
Pluggable Transceivers Supported on OCX1100 Switches
This topic describes the optical interfaces supported for SFP+ and QSFP+ transceivers.
NOTE: We recommend that you use only optical transceivers and optical
connectors purchased from Juniper Networks with your Juniper Networks
device.
CAUTION: If you face a problem running a Juniper Networks device that uses
a third-party optic or cable, the Juniper Networks Technical Assistance Center
(JTAC) can help you diagnose the source of the problem. Your JTAC engineer
might recommend that you check the third-party optic or cable and potentially
replace it with an equivalent Juniper Networks optic or cable that is qualified
for the device.
The 10-gigabit SFP+ and 40-gigabit QSFP+ transceivers installed in OCX1100 switches
support digital optical monitoring (DOM): You can view the diagnostic details for these
transceivers by issuing the operational mode CLI command
show interfaces diagnostics
optics
.
The tables in this topic describe the optical interface support over single-mode fiber-optic
(SMF) and multimode fiber-optic (MMF) cables for SFP+ and QSFP+ transceivers:
• Table 28 on page 48 —Optical interface support for SFP+ transceivers.
• Table 29 on page 50 —Optical interface support for QSFP+ transceivers.
47 Copyright © 2017, Juniper Networks, Inc.