Juniper OCX1100, Hardware Manual

Page: 139 / 204

WARNING: Do not look directly into a fiber-optic transceiver or into the
ends of fiber-optic cables. Fiber-optic transceivers and fiber-optic cables
connected to transceivers emit laser light that can damage your eyes.
Figure 40: Installing a Transceiver
1— Ejector lever
Related
Documentation
Removing a Transceiver on page 119
•
•
Connecting a Fiber-Optic Cable on page 89
Removing a Transceiver
The transceivers for Juniper Networks devices are hot-removable and hot-insertable
field-replaceable units (FRUs): You can remove and replace them without powering off
the device or disrupting device functions.
NOTE: After you remove a transceiver or when you change the media-type
configuration, wait for 6 seconds for the interface to display the operational
commands.
Before you begin removing a transceiver from a device, ensure that you have taken the
necessary precautions for safe handling of lasers (see
“Laser and LED Safety Guidelines
and Warnings” on page 155 ).
Ensure that you have the following parts and tools available:
• An antistatic bag or an antistatic mat
• Rubber safety caps to cover the transceiver and fiber-optic cable connector
•
A dust cover to cover the port
Figure 41 on page 121 shows how to remove a QSFP+ transceiver. The procedure is the
same for all types of transceivers except the CFP transceivers.
119 Copyright © 2017, Juniper Networks, Inc.
Chapter 16: Replacing Transceiver