Juniper OCX1100, Hardware Manual

Page: 134 / 204

Figure 38: Installing a DC Power Supply in an OCX1100-48SX Switch
NOTE: If you have a Juniper J-Care service contract, register any addition,
change, or upgrade of hardware components at
https://www.juniper.net/customers/csc/management/updateinstallbase.jsp
.
Failure to do so can result in significant delays if you need replacement parts.
This note applies if you change the type of power supply or add a new type
of uplink module. It does not apply if you replace these components with the
same type of component.
Related
Documentation
Removing a DC Power Supply from an OCX1100 Switch on page 114
•
•
DC Power Supply in OCX1100 Switches on page 25
•
Connecting DC Power to an OCX1100 Switch on page 82
•
OCX1100 Switches Hardware Overview on page 3
Removing a DC Power Supply from an OCX1100 Switch
The power supply in OCX1100 switches is a hot-removable and hot-insertable
field-replaceable unit (FRU) installed in the rear panel of the switch: You can remove
and replace it without powering off the switch or disrupting switch functions.
Before you begin removing a power supply from the switch:
• Ensure you understand how to prevent electrostatic discharge (ESD) damage. See
“Prevention of Electrostatic Discharge Damage” on page 167 .
Ensure that you have the following parts and tools available to remove the power supply
from the switch chassis:
•
ESD grounding strap
•
Phillips (+) screwdriver
• An antistatic bag or an antistatic mat
•
Replacement power supply or a cover panel for the power supply slot
Copyright © 2017, Juniper Networks, Inc. 114
OCX1100 Switch Hardware Guide