Juniper OCX1100, Hardware Manual

Page: 91 / 204

3.
Attach the rubber feet to the bottom of the chassis, as shown in Figure 20 on page 71 .
4.
Turn the chassis right side up on the desk or the level surface.
Figure 20: Attaching Rubber Feet to the Switch Chassis
Related
Documentation
Connecting AC Power to an OCX1100 Switch on page 80
•
•
Connecting DC Power to an OCX1100 Switch on page 82
•
Connecting and Configuring an OCX1100 Switch (CLI Procedure) on page 100
•
Clearance Requirements for Airflow and Hardware Maintenance for OCX1100 Switches
on page 37
Mounting an OCX1100 Switch on Four Posts of a Rack or Cabinet
You can mount an OCX1100 switch on four posts of a 19-in. rack or a 19-in. cabinet by
using the mounting brackets provided with the switch. (The remainder of this topic uses
rack to mean rack or cabinet .)
Before mounting the switch on four posts of a rack:
•
Verify that the site meets the requirements described in “Site Preparation Checklist
for OCX1100 Switches” on page 31 .
• Place the rack in its permanent location, allowing adequate clearance for airflow and
maintenance, and secure it to the building structure.
•
Read “General Safety Guidelines and Warnings” on page 137 , with particular attention
to “Chassis Lifting Guidelines” on page 146 .
• Remove the switch from the shipping carton (see “Unpacking an OCX1100 Switch” on
page 65 ).
Ensure that you have the following parts and tools available:
• Phillips (+) screwdriver (not provided)
•
Eight Phillips-head front rack-mounting bracket screws (provided)
•
Eight rack-mounting screws to secure the front rack-mounting brackets and the
rack-mounting slider brackets to the chassis (not provided)
• One pair of front rack-mounting brackets (provided)
•
One pair of rack-mounting slider brackets (provided)
71 Copyright © 2017, Juniper Networks, Inc.
Chapter 10: Installing the Switch