Juniper OCX1100, Hardware Manual

Page: 132 / 204

6.
Press the clip to the left and grasp the power supply handle and pull firmly to slide
the power supply halfway out of the chassis.
7.
Place one hand under the power supply to support it and slide it completely out of
the chassis. Take care not to touch power supply components, pins, leads, or solder
connections.
8.
Place the power supply in the antistatic bag or on the antistatic mat placed on a flat,
stable surface.
9.
If you are not replacing the power supply, install the cover panel over the slot.
Figure 37 on page 112 shows how to remove an AC power supply from an OCX1100 switch.
Figure 37: Removing an AC Power Supply from an OCX1100-48SX Switch
g000685
Related
Documentation
Installing an AC Power Supply in an OCX1100 Switch on page 77
•
•
Installing and Removing OCX1100 Switch Hardware Components on page 74
•
AC Power Supply Specifications for OCX1100 Switches on page 41
•
Field-Replaceable Units in OCX1100 Switches on page 12
•
AC Power Cord Specifications for an OCX1100 Switch on page 41
•
OCX1100 Switches Hardware Overview on page 3
Installing a DC Power Supply in an OCX1100 Switch
The DC power supply in OCX1100 switches is a hot-removable and hot-insertable
field-replaceable unit (FRU) installed in the rear panel of the switch: You can remove
and replace it without powering off the switch or disrupting switch functions.
CAUTION: Do not install:
• AC and DC power supplies in the same chassis.
• AC power supplies in DC switch models or DC power supplies in AC switch
models.
Copyright © 2017, Juniper Networks, Inc. 112
OCX1100 Switch Hardware Guide