Juniper OCX1100, Hardware Manual

Page: 100 / 204

3.
If the power supply slot has a cover panel on it, loosen the captive screws on the cover
panel by using your fingers or the screwdriver. Hold the captive screw and gently pull
it outward to remove the cover panel. Save the cover panel for later use.
4.
Taking care not to touch power supply pins, leads, or solder connections, remove the
power supply from the bag.
5.
Using both hands, place the power supply in the power supply slot on the rear panel
of the switch and slide it in until it is fully seated and the clip clicks into place. See
Figure 25 on page 80
Figure 25: Installing a DC Power Supply in an OCX1100-48SX Switch
NOTE: If you have a Juniper J-Care service contract, register any addition,
change, or upgrade of hardware components at
https://www.juniper.net/customers/csc/management/updateinstallbase.jsp .
Failure to do so can result in significant delays if you need replacement parts.
This note applies if you change the type of power supply or add a new type
of uplink module. It does not apply if you replace these components with the
same type of component.
Related
Documentation
Removing a DC Power Supply from an OCX1100 Switch on page 114
•
•
DC Power Supply in OCX1100 Switches on page 25
•
Connecting DC Power to an OCX1100 Switch on page 82
•
OCX1100 Switches Hardware Overview on page 3
Connecting AC Power to an OCX1100 Switch
The AC-powered models of (see “OCX1100 Switch Models” on page 6 ) OCX1100 switches
support 460 W AC power supplies. After you install at least one power supply, you can
connect power to the switch.
CAUTION: Do not install:
Copyright © 2017, Juniper Networks, Inc. 80
OCX1100 Switch Hardware Guide