Juniper JUNOSE 11.1.X - BROADBAND ACCESS CONFIGURATION GUIDE 6-4-2010, Configuration Manual

Page: 681 / 794

Chapter 27
Configuring Service Manager
This chapter describes how to use the Service Manager application to define, activate,
and monitor networking services for your subscribers. This chapter discusses the
following topics:
■
Service Manager Overview on page 641
■
Service Manager Platform Considerations on page 643
■
Service Manager References on page 643
■
Service Manager Configuration Tasks on page 643
■
Service Definitions on page 645
■
Referencing Policies in Service Definitions on page 650
■
Referencing QoS Configurations in Service Definitions on page 651
■
Configuring the Service Manager License on page 659
■
Managing and Activating Service Sessions on page 660
■
Using RADIUS to Manage Subscriber Service Sessions on page 660
■
Using Mutex Groups to Activate and Deactivate Subscriber Services on page 667
■
Combined and Independent IPv4 and IPv6 Services in a Dual Stack
Overview on page 669
■
Activation and Deactivation of IPv4 and IPv6 Services in a Dual Stack on page 670
■
Configuring RADIUS Accounting for Service Manager on page 672
■
Using the CLI to Manage Subscriber Service Sessions on page 677
■
Configuring Service Manager Statistics on page 686
■
Service Manager Performance Considerations on page 690
■
Service Definition Examples on page 690
Service Manager Overview
The JUNOSe Service Manager application provides authentication, service selection,
and service activation and deactivation to subscribers. The application also collects
accounting information and statistics, and monitors subscriber and service sessions.
Service Manager supports two client types—RADIUS and CLI. Service Manager starts
when it receives a request from a RADIUS or CLI client. For RADIUS clients, RADIUS
Access-Accept messages and Change-of-Authorization-Request (CoA-Request)
Service Manager Overview
■ 641