Juniper JUNOSE 11.1.X - BROADBAND ACCESS CONFIGURATION GUIDE 6-4-2010, Configuration Manual

Page: 222 / 794

4.
For this attribute to be included, an IPv6 interface ID must be assigned to the
subscriber.
5.
For this attribute to be included, at least one IPv6 prefix must be assigned to the
subscriber.
Table 39: AAA Accounting Message RADIUS IETF Attributes Supported
Acct-Off Acct-On Interim-Acct Acct-Stop Acct-Start Attribute Name
Attribute
Number
– –
✓ ✓ ✓
User-Name [1]
✓ ✓ ✓ ✓ ✓
NAS-IP-Address [4]
– –
✓ ✓ ✓
NAS-Port [5]
– –
✓ ✓ ✓
Service-Type [6]
– –
✓ ✓ ✓
Framed-Protocol
(See Note 3.) [7]
– –
✓ ✓ ✓
Framed-IP-Address
(See Note 2.) [8]
– –
✓ ✓ ✓
Framed-IP-Netmask [9]
– –
✓ ✓ ✓
Framed-Compression
(See Note 3.) [13]
– –
✓ ✓ ✓
Class [25]
– –
✓ ✓ ✓
Called-Station-Id [30]
– –
✓ ✓ ✓
Calling-Station-Id [31]
✓ ✓ ✓ ✓ ✓
NAS-Identifier [32]
✓ ✓ ✓ ✓ ✓
Acct-Status-Type [40]
✓ ✓ ✓ ✓ ✓
Acct-Delay-Time [41]
– –
✓ ✓
– Acct-Input-Octets [42]
– –
✓ ✓
– Acct-Output-Octets [43]
✓ ✓ ✓ ✓ ✓
Acct-Session-Id [44]
✓ ✓ ✓ ✓ ✓
Acct-Authentic [45]
– –
✓ ✓
– Acct-Session-Time [46]
– –
✓ ✓
– Acct-Input-Packets [47]
– –
✓ ✓
– Acct-Output-Packets [48]
✓
– –
✓
– Acct-Terminate-Cause [49]
182 ■
Subscriber AAA Accounting Messages
JUNOSe 11.1.x Broadband Access Configuration Guide