Juniper JUNOSE 11.1.X - BROADBAND ACCESS CONFIGURATION GUIDE 6-4-2010, Configuration Manual

Page: 483 / 794

Table 89: show l2tp session Output Fields (continued)
Field Description Field Name
Whether or not the router sends traps to Simple
Network Management Protocol (SNMP) for
operational state changes SNMP traps
Session status of the destination Session status
Most restrictive of the following administrative states:
router, destination, tunnel, and session. This setting,
rather than the administrative state of the session,
determines whether the router can maintain this
session or not. Effective administrative state
Status of the session: idle, connecting, established,
or disconnecting State
Names the router uses to identify the session locally
and remotely Local and peer session id
Information about the traffic for this session Statistics
Information received from the peer when the session
was created Session operational configuration
Related Topics
■
show l2tp session
Monitoring Configured and Operational Summary Status
Purpose
Display a summary of the configured and operational status of all L2TP sessions.
Action
To display a summary of the configured and operational status of all L2TP sessions:
host1# show l2tp session summary
Administrative status enabled disabled
64 0
Operational status up down lower-down not-present
64 0 0 0
Meaning
Table 90 on page 444 lists the show l2tp session summary command output fields.
Monitoring Configured and Operational Summary Status
■ 443
Chapter 16: Monitoring L2TP and L2TP Dial-Out