Juniper JUNOSE 11.1.X - BROADBAND ACCESS CONFIGURATION GUIDE 6-4-2010, Configuration Manual

Page: 241 / 794

■
Format for Ethernet interfaces that use fixed-format-adapter-new-field
stacked :
<system name [4]> <slot [2]> <adapter [1]><port [2] <S-VLAN [4]
<VLAN [4]>
By default, these formats do not include the S-VLAN ID unless you specify
the optional
stacked keyword. If you include the stacked keyword, the
S-VLAN ID is displayed in decimal format in the range 0–4095.
The S-VLAN ID field in the Calling-Station-Id [31] attribute is set to 0 (zero)
under the following conditions:
■
You do not specify the optional stacked keyword.
■
You specify the optional stacked keyword but the Ethernet interface does
not have an S-VLAN ID.
■
Attribute 31, Calling-Station-Id, is used with Attribute 30, Called-Station-Id, in a
standard way when the router is the LNS and the LAC is a dial-up LAC (not an E
Series router). When the LNS receives the Calling-Station-Id and Called-Station-Id
AVPs, the router includes the values as they are, with no format changes in the
RADIUS messages.
■
Example 1
host1(config)# radius calling-station-format fixed-format
For example, when you configure this Calling-Station-Id format on an E320 router
for an ATM interface on system name eastern, slot 14, adapter 1, port 2, VCI 3,
and VPI 4, the virtual router displays the format in ASCII as ‘14’ ‘2’ ‘003’ ‘00004’.
The adapter number does not appear in this format.
■
Example 2
host1(config)# radius calling-station-format fixed-format-adapter-embedded
For example, when you configure this Calling-Station-Id format on an E320 router
for an ATM interface on system name eastern, slot 14, adapter 1, port 2, VCI 3,
and VPI 4, the virtual router displays the format in ASCII as
‘E’ ‘1’ ‘2’ ‘003’ ‘00004’.
■
Example 3
host1(config)# radius calling-station-format fixed-format-adapter-new-field
For example, when you configure this Calling-Station-Id format on an E320 router
for an ATM interface on system name eastern, slot 14, adapter 1, port 2, VCI 3,
and VPI 4, the virtual router displays the format in ASCII as
‘14’ ‘1’ ‘02’ ‘003’ ‘00004’.
■
Example 4
host1(config)# radius calling-station-format fixed-format-adapter-new-field stacked
For example, when you configure this Calling-Station-Id format on an E320 router
for an Ethernet interface on system name western, slot 4, adapter 1, port 3,
S-VLAN ID 8, and VLAN ID 12, the virtual router displays the format in ASCII as
‘west’ ‘04’ ‘1’ ‘03’ ‘0008’ ‘0012’.
CLI Commands Used to Modify RADIUS Attributes
■ 201
Chapter 3: Configuring RADIUS Attributes