Juniper JUNOSE 11.1.X - BROADBAND ACCESS CONFIGURATION GUIDE 6-4-2010, Configuration Manual

Page: 307 / 794

Table 50: Juniper Networks (Vendor ID 4874) VSA Formats (continued)
Value
Subtype
Length
Length Description Attribute Name
Attribute
Number
integer: 1= UBR,
2 = UBR PCR,
3 = NRT VBR,
4 = CBR
5 = RT VBR, 6 12 ATM service category to apply to B-RAS
user’s interface Service-Category [26-14]
integer: 4-octet 6 12
■
Peak cell rate
■
4-octet integer
PCR [26-15]
integer: 4-octet 6 12
■
Sustained cell rate
■
4-octet integer
SCR [26-16]
integer: 4-octet 6 12
■
Maximum burst rate
■
4-octet integer
Mbs [26-17]
single attribute: enter
0, 1, 5, 10, or 15 sublen len
■
Specifies the initial level of access to
CLI commands
■
See the enable command in the
Passwords and Security chapter in
JUNOSe System Basics Configuration
Guide
.
Init-CLI-Access-Level [26-18]
integer: 0 = disable,
1 = enable sublen len
■
Specifies user access to all virtual
routers
■
See the enable command in the
Passwords and Security chapter in
JUNOSe System Basics Configuration
Guide
.
Allow-All-VR-Access [26-19]
single attribute; enter
0, 1, 5, 10, or 15 sublen len
■
Specifies other levels of access to CLI
commands
■
See the enable command in chapter
Passwords and Security in JUNOSe
System Basics Configuration Guide .
Alt-CLI-Access-Level [26-20]
string:
virtual-router-name sublen len
■
For restricted users, specifies other
VRs that the user may access.
■
See the enable command in chapter
Passwords and Security in JUNOSe
System Basics Configuration Guide .
Alt-CLI-Vrouter-Name [26-21]
integer: 0 = disable,
1 = enable sublen len
■
Enable or disable source address
validation on a user’s interface
■
4-octet integer
Sa-Validate [26-22]
integer: 0 = disable,
1 = enable sublen len
■
Enable or disable IGMP on a user’s
interface
■
Allows the end user to register for the
reception of multicast services
■
4-octet integer
Igmp-Enable [26-23]
Juniper Networks VSAs
■ 267
Chapter 6: RADIUS Attribute Descriptions