Juniper JUNOSE 11.1.X - BROADBAND ACCESS CONFIGURATION GUIDE 6-4-2010, Configuration Manual

Page: 275 / 794

■
IPv6-Acct-Input-Gigawords [26-155]
■
IPv6-Acct-Output-Gigawords [26-156]
If you enable inclusion of the IPv6 accounting-related VSAs in Acct-Stop messages,
the router also includes the VSAs in Interim-Acct messages.
■
You can control inclusion of the IPv6 accounting attributes by enabling or
disabling this command.
■
See radius include
■
Example
host1(config)# radius include ipv6-accounting acct-stop enable
■
Use the no version to restore the default, disable.
[26-159] DHCP-Option 82
Use the following command to manage the DHCP Option 82 RADIUS attribute.
■
radius include dhcp-option-82
radius include dhcp-option-82
Use to include the DHCP Option 82 attribute in Access-Request, Acct-Start, and
Acct-Stop messages.
■
■
You can configure RADIUS to include the dhcp-option-82 attribute
■
See radius include
■
Example
host1(config)# radius include dhcp-option-82
■
Use the no version to restore the default, disable.
ANCP-Related Juniper Networks VSAs
You use the radius include command to specify information about Access Node
Control Protocol (ANCP), also known as Layer 2 Control (L2C), that you want to
include in the RADIUS Access-Request, Acct-Start, and Acct-Stop messages. Also, if
you specify Acct-Stop messages, the router includes ANCP information in Interim-Acct
messages that the router sends to RADIUS. By default, the router does not include
the ANCP-related information provided by the Juniper Networks VSAs in RADIUS
messages.
These Juniper Networks ANCP-related VSAs are based on definitions in GSMP
extensions for layer2 control (L2C) Topology Discovery and Line
Configuration—draft-wadhwa-gsmp-l2control-configuration-00.txt (July 2006
expiration).
radius include l2cd-keyword
CLI Commands Used to Modify RADIUS Attributes
■ 235
Chapter 3: Configuring RADIUS Attributes