Juniper JUNOSE 11.1.X - BROADBAND ACCESS CONFIGURATION GUIDE 6-4-2010, Configuration Manual

Page: 581 / 794

Setting a Baseline for DHCP External Server Statistics
To set a baseline for DHCP external server statistics.
■
Issue the baseline ip dhcp-external command:
host1# baseline ip dhcp-external
There is no no version.
Setting a Baseline for DHCP Local Server Statistics
To set a baseline for DHCP local server statistics:
■
Issue the baseline ip dhcp-local command:
host1# baseline ip dhcp-local
There is no no version.
To set a baseline for DHCP local server statistics for a specific ATM, Fast Ethernet,
or Gigabit Ethernet interface:
■
Issue the baseline ip dhcp-local command with the optional interface keyword
to specify the type of interface and interface specifier:
host1# baseline ip dhcp-local interface atm 3/1
To set a baseline for DHCPv6 local server statistics:
■
Issue the baseline ipv6 dhcpv6-local command:
host1# baseline ipv6 dhcpv6-local
Monitoring Addresses Excluded from DHCP Local Server Use
Purpose
Display addresses that have been excluded by the ip dhcp-local excluded-address
command. The DHCP local server does not allocate excluded addresses, because
they are already used by devices on the subnetwork.
Action
To display excluded IP addresses:
host1(config)# show ip dhcp-local excluded
Dhcp Excluded Addresses
-----------------------
Low High
Pool Address Address
-------- --------- ----------
default 10.10.1.1
default 10.10.1.5 10.10.1.30
cable2 10.10.2.1
Setting a Baseline for DHCP External Server Statistics
■ 541
Chapter 22: Monitoring and Troubleshooting DHCP