Jungheinrich DFG 425s, Operating Instructions Manual, Page: 92 / 229

91
03.13 EN
NOTE
Loads must not be deposited on travel or escape routes, in front of safety mechanisms
or operating equipment that must be accessible at all times.
Transporting loads
Requirements
– Load raised correctly.
– Load handler lowered for transport (approx. 150 - 200 mm above the ground).
– Mast tilted back fully.
Procedure
• Accelerate and decelerate sensitively.
• Adapt your travel speed to the conditions of the route and the load you are
transporting.
• Watch out for other traffic at crossings and passageways.
• Always travel with a lookout at blind spots.
• On slopes and inclines always carry the load facing uphill, never approach at an
angle or turn.
Depositing loads
Requirements
– Storage location suitable for storing the load.
Procedure
• Set the mast vertical.
• Drive the truck carefully up to the storage location.
• Carefully lower the load handler so that the forks are clear of the load.
Z
Avoid depositing the load to prevent damage to the load and the load handler.
• Lowers the load handler.
• Carefully remove the forks from the pallet.
The load is deposited.