77
03.13 EN
4.3
Starting procedure for the DFG
Procedure
• Insert the key in the key switch (81). Set
key switch to “I”.
• The pre-heat indicator lamp lights up
and goes out automatically as soon as
the required pre-heat time (approx. 4
seconds) has been reached.
•
• All the indicators go on briefly as a
function check and the (102) display is
activated.
Z
All the warning indicators apart from the
engine oil pressure display (88), parking
brake (89), truck in operation indicator
lamp (102) and charge current warning
indicator (93) should go out after a short
while. If not, stop the start-up process
and rectify the fault.
• Using the key, set the key switch (81) to
“II” to apply the starter.
Z
Only apply the starter continuously for a
maximum of 15 seconds.
The truck is equipped with an
immobiliser which prevents it from
starting again while the engine is
running.
• Release the key as soon as the engine starts. The key switch automatically reverts
to the "I" position.
Z
All indicators except for the parking brake (89) and the truck operational indicator
(102) should go out as soon as the engine starts. If not, switch off the engine
immediately and rectify the fault.
• Test the brake pedal and parking brake button (105).
Truck is operational.
0
I
II
81
km/h
R
73
92
88
93
89 97
102
105
Summary of Contents for DFG 425s
