Jungheinrich DFG 425s, Operating Instructions Manual, Page: 214 / 229

213
03.13 EN
Load backrest
Lift Control
Particle filter
Safety restraint system / SUN protector
Impact sensor
Sideshifter
Hydraulic operations W A B C
1
Check attachment is properly secured to the truck and the
supporting elements.
t
Hydraulic operations W A B C
1 Check the "Lift Control".
t
Travel W A B C
1
Note: Any work carried out on the particle filter system must only be
performed by specialist personnel.
2
Particle filter: Clean filter in accordance with the manufacturer's
instructions.
t
3
Test the particle filter system. Check its setting and check for
contamination, clean if necessary.
t
4
Measure the soot index according to the manufacturer's
specifications or national regulations.
o
Chassis and Superstructure W A B C
1
Make sure restraint system is complete, test operation and check for
damage.
t
Electrical System W A B C
1 Check impact sensor is secure and check for damage.
t
Hydraulic operations W A B C
1 Check axial play of the front and rear rollers and adjust if necessary.
t
2
Check attachment is properly secured to the truck and the
supporting elements.
t
3 Test attachment, check settings and check for damage.
t
4 Check sliding blocks are complete.
t
5
Check attachment bearing points, guides and stops for wear and
damage, grease and clean these components.
t