Commis s ioning and configuration
KNX Sonos -Gateway
MR-SONOS-REG
© 2019 Albrecht J ung GmbH & Co. KG
p. 57 / 118
Manually resetting the device to the factory settings
Requirement: The device is switched off.
1. Press the programming button (1) and keep it pressed while you switch on
the device.
Continue to hold the programming button down.
2. Wait until the following LEDs all start to flash slowly at the same time:
•
Programming LED (4)
•
APP LED (5)
•
COM-LED (6)
3.
Releas e the programming button briefly.
4.
Pres s the programming button again and keep it pres s ed until following
LEDs are all flas hing rapidly at the s ame time:
•
Programming LED (4)
•
APP LED (5)
•
COM-LED (6)
5.
Releas e the programming button.
The device is reset to the factory settings.
You do not have to restart the device.
Resetting the device to the factory settings via a function on the device website
1.
Open the device webs ite.
Section
2.
Select <<Sys tem>>
<<Factory res et>> in the menu bar.
3.
Confirm the confirmation prompt.
The start screen is displayed as soon as the device is reset to its factory settings.
The device does not have to be restarted.
8.2.6
Transferring application programs and configuration data
After programming the phys ical addres s , the application program, parameter settings and group addres s
connections can be trans ferred to the device.
The connection to the device can be further establis hed via a direct IP connection or KNX/TP for this purpos e.
We recommend us ing the direct IP connection due to the s ignificantly s horter trans fer times .
Select the tab <<Bus >>
<<Connections >>
<<Options >>
<<Us e direct IP connection if
available>>.
Transfer project planning data
1.
Select <<Commiss ioning>>
<<Programme>>
<<Application program>>.
2.
Wait after the download while the device copies the data and ins talls the application.
Commissioning is complete.
