JLG 680S, Service And Maintenance Manual

Page: 433 / 530

SECTION 6 - JLG CONTROL SYSTEM
3121234 6-17
LOAD SYSTEM:
17*
* Only visible under certain
market selections.
* Certain market selections
will limit load system
options or alter default set-
ting.
* LOAD SYSTEM will not be
visible in CE and defaulted to
CUTOUT ALL for machines
equipped with MSSO. 0
1
2
3
4
NO: No load sensor installed.
WARN ONLY: Functions in creep, overload lamp lit, platform alarm beeps (5 sec ON, 2 sec OFF).
CUTOUT PLATFORM: All functions cutout, overload lamp lit, platform alarm beeps (5 sec ON, 2 sec OFF).
CUTOUT ALL: All functions cutout, flash overload light (500mS on, 500mS off), platform alarm beeps (5 sec
ON, 2 sec OFF).
SPECIAL 1: Functions in creep, overload lamp lit, disables main telescope out & main lift up, platform alarm
beeps (5 sec ON, 2 sec OFF).
0
LOAD SENSOR:
18*
* Only visible if Load Sensor
Menu selection is not 0 and
under certain market selec-
tions.
* Certain market selections
will limit load sensor
options. 0
1
2
1 ON ROTATOR: Use the on-board load sensor for all models except those which use the Leveling Platform
Module.
4 UNDER PLATFORM: Use the EIM for load sensing.
SINGLE CELL: Single Cell, CANbus based sensor.
1
FUNCTION CUTOUT:
19*
* Only visible under certain
market selections.
* Certain market selections
will limit function cutout
options or alter default set-
ting. 0
1
2
3
NO: No drive cutout.
BOOM CUTOUT: Boom function cutout while driving above elevation.
DRIVE CUTOUT: Drive & steer cutout above elevation.
DRIVE CUT E&T: Drive & steer cutout above elevation and tilted.
0
GROUND ALARM:
20*
* Certain market selections
will alter default setting. 0
1
2
3
NO: No ground alarm installed.
DRIVE: Travel alarm sounds when the drive function is active (Option).
DESCENT: Descent alarm sounds when lift down is active (Option).
MOTION: Motion alarm sounds when any function is active (Option).
3
DRIVE:
21*
* Only visible under certain
model selections. 0
1
2
4WD: Four wheel drive.
2WD: Two wheel drive.
2WD W/ 2-SPEED: Two wheel drive with 2-speed valve.
0
Table 6-3. Machine Configuration Programming Information (Software Version P5.X)
Configuration Digit Number Description
Default
Number