JLG 680S, Service And Maintenance Manual

Page: 425 / 530

SECTION 6 - JLG CONTROL SYSTEM
3121234 6-9
GLOW PLUG:
5 0
1
2
NO GLOW PLUGS: No glow plugs installed.
W/O STARTER LOCK: Automatic pre-glow time determined by ambient air temperature;
engine start can be attempted at any time during pre-glow.
W/ STARTER LOCK: Automatic pre-glow time determined by ambient air temperature; engine start is NOT
permitted until pre-glow is finished.
1
ENGINE SHUTDOWN:
6 0
1
DISABLED: No engine shutdown.
ENABLED: Shutdown engine when coolant temperature is greater than 110 deg. C or the oil
pressure is less than 8 psi.
1
TILT:
7*
* Certain market selections will limit
tilt options.
1
2
3
4
5
5 DEGREES: Reduces the maximum speed of all boom functions to creep when tilted more
than 5 degrees and above elevation; also reduces drive speed to creep.
4 DEGREES: Reduces the maximum speed of all boom functions to creep when tilted more than 4 degrees
and above elevation; also reduces drive speed to creep.
3 DEGREES: Reduces the maximum speed of all boom functions to creep when tilted more than 3 degrees
and above elevation; also reduces drive speed to creep.
4 D CUT: Reduces the maximum speed of all boom functions to creep when tilted more than 4
degrees and above elevation; also disallows tower lift up, tower telescope out, drive, main telescope out
and main lift up.
3 D CUT: Reduces the maximum speed of all boom functions to creep when tilted more than 3
degrees and above elevation; also disallows tower lift up, tower telescope out, drive, main telescope out
and main lift up.
Note: Any of the selections above will light the tilt lamp when a tilted condition occurs and will sound the
platform alarm when the machine is also above elevation.
1
JIB:
8*
* Only visible under certain
model selections 0
1
NO: No jib installed.
YES: Jib installed which has up and down movements only.
0
4 WHEEL STEER:
9*
* Only visible under certain model
selections.
0
1
NO: No four-wheel steer installed.
YES: Four-wheel steer installed.
0
SOFT TOUCH:
10*
* Only visible under certain model
selections.
0
1
NO: No soft touch system installed.
YES: Soft touch system installed.
0
GEN SET/WELDER:
11 0
1
NO: No generator installed.
BELT DRIVE: Belt driven setup.
0
Table 6-2. Machine Configuration Programming Information
Configuration Digit Number Description Default Number