Page 21
| Fathom
ICS
IN-CEILING INSTALLATION
Type: IC-2
Test Fit Enclosure
With the assistance of a helper, lift
the enclosure into the ceiling cavity,
positioning the Extended Stud Mounts
(Parts G & H) above the ends of the
Joist Mounting Brackets (Parts E & F)
and slide the enclosure inward until
the Extended Stud Mounts (Parts
G & H) contact the Joist Mounting
Brackets (Parts E & F). To prevent the
enclosure from falling out, ensure that
the exposed dowel pins at the ends of
the Extended Stud Mounts (Parts G
& H) are located on the outside of the
Joist Mounting Brackets (Parts E & F).
(Figure 12)
Set the Enclosure’s Final Position
Adjust the position of the
enclosure so that the narrow ends
of the Extended Stud Mounts (Parts
G & H) are centered below the
joists. Ensuring that no sides of the
enclosure are in contact with the
joists, will reduce the potential for
unwanted noise and vibration.
Install two #8 x 2.00-inch pan
head screws through the guide holes
located at each end of the Extended
Stud Mounts (Parts G & H) to set the
enclosure’s final position. Select the
guide hole locations that will place
each screw at or near the center of
each joist.
(Figure 13)
Note: As this is the last
opportunity before permanently
mounting the enclosure, we highly
recommend to double-check
that the position of the driver/
grille (Wallboard Template -
Part A) is at the desired location
within the floor plan.
Figure 12
Figure 13
Arrows point to pre-drilled
attachment holes locations.
Summary of Contents for FATHOM ICS-SYS-108
