| Fathom
ICS
Page 16
IN-CEILING INSTALLATION
Type: IC-1
Mounting the Enclosure
Place an L-Bracket (Part J) at one of
the corner ends of the enclosure, with
its slotted openings positioned over
the pilot holes. Within each slotted
opening, select two non-adjacent pilot
holes (spaced one to two holes apart)
and fully install two #8 x 1.00-inch
pan head screws. Then, partially back
out each screw, leaving just one to two
threads exposed beneath each screw
head. The L-Bracket should remain
loose, allowing it to slide for adjustment
during installation.
(Figure 6)
Slide the L-Bracket (Part J)
outward and secure to the ceiling joist
using six #8 x 1.25-inch wafer head
screws. Repeat this procedure with
the remaining L-Brackets (Part J)
at the remaining corner ends of the
enclosure. Next, fully tighten all screws
previously installed in the slotted
openings and lock the position of all
L-Brackets (Part J) by installing a #8 x
1.00-inch pan head screw into one of
the two holes located in between the
slotted openings.
(Figure 7)
Uninstall all screws from all Joist
Mounting Brackets (Parts E & F) and
remove for recycling. Uninstall all
screws from both Stud Mounts (Parts
B & C) and remove for recycling.
PROCEED TO ROUTING THE
SPEAKER CABLE (page 30)
Figure 6
Figure 7
2
3
1
Summary of Contents for FATHOM ICS-SYS-108
