Page 19
| Fathom
ICS
IN-CEILING INSTALLATION
Type: IC-2
Understanding the Extended
Stud Mounts
The Extended Stud Mounts (Parts G
& H) are designed so the enclosure can
be positioned at the center of the ceiling
cavity or towards a joist, away from the
wide end of the Extended Stud Mounts
(Parts G & H).
= Wide End
= Narrow End
To position the enclosure in the
opposite direction, simply rotate the
orientation of the Extended Stud
Mounts (Parts G & H).
Note: Regardless of orientation,
each Extended Stud Mount (Parts G &
H) must remain within its respective
Joist Mounting Bracket (Parts E & F).
(Figure 9)
Determine the Enclosure’s Center
Place the Extended Lower Stud
Mount (Part H) into the bottom Joist
Mounting Brackets (Parts E & F), with
its narrow end, centered below the
joist.
(Figure 10)
Mark a line on the edge of the
Extended Lower Stud Mount (Part
H), at the desired center position of
the enclosure.
Note: The enclosure’s
final position within the ceiling
cavity requires at least 7.50-inches
of unobstructed space, in either
direction from the enclosure’s center,
towards the bordering joists.
After marking the enclosure’s
desired center position, transfer (copy)
this mark from the Extended Lower
Stud Mount (Part H) to the Extended
Upper Stud Mount (Part G).
Figure 9
Figure 10
Center narrow
end below joist.
7.50-inches
minimum
7.50-inches
minimum
Desired Center
of Enclosure
Summary of Contents for FATHOM ICS-SYS-108
