| Fathom
ICS
Page 30
ROUTING THE
SPEAKER CABLE
Route speaker cable to the push
terminals located at the bottom of
the enclosure and remove the outer
jacketing to expose the individual
wires. Two rubber covers are
included to insulate the speaker
terminals. Feed the individual
wires through each rubber cover
and remove the wire insulation.
While observing correct polarity,
connect the individual wires to the
push terminals, then slide a rubber
cover over each terminal.
(Figure 26)
Note: To reduce the potential for
unwanted noise and vibration, secure
the speaker cable and individual
wires so they do not come into
contact with any surrounding parts
(enclosure, mounting brackets,
joists, studs, wallboard surfaces or
any other surfaces within the ceiling
cavity). Any loose contact point
may lead to undesirable rattles or
buzzing, which may be inaccessible
once the surrounding wallboard has
been installed.
Figure 26
Summary of Contents for FATHOM ICS-SYS-108
