Page 33
| Fathom
ICS
Grille Assembly Installation
With the Wallboard Template (Part
A) removed, test fit the grille tray by
inserting it into the opening with the
JL Audio logo positioned at the bottom
of the enclosure.
(Figure 2)
The grille
tray’s outer edge should make contact
with the outer wallboard surface.
Refer to the table on the previous
page to select the correct thumb
screw length and secure the grille tray
in place using four thumb screws,
with each thumb screw installed
into the threaded inserts located
within the enclosure. Tighten each
thumb screw by hand, being careful
not to over tighten.
(Figure 3)
Rubber screw stoppers are included
to prevent the thumb screws from
loosening. To install, press a rubber
stopper over each thumb screw
with the “THIS SIDE DOWN”
imprint facing against the enclosure.
Position each rubber stopper with
its narrow tip pointing towards the
corners of the grille tray.
(Figure 4)
The outer metal mesh grille fits
in the center of the grille tray and
is held in place with embedded
magnets. To install, simply bring
the mesh grille near the grille tray,
allowing the magnets to pull it into the
recesses of the grille tray.
(Figure 5)
This completes the installation of
the IWG-108 grille.
Figure 3
Figure 2
Figure 5
Figure 4
Summary of Contents for FATHOM ICS-SYS-108
