| Fathom
ICS
Page 28
IN-WALL INSTALLATION
Type: IW-1
Set the Enclosure Position
Place the enclosure into the
wall cavity, with both Stud Mounts
(Parts B & C) pressed against
the stud faces and supported by
the Floor Support (Part D).
Using a level and the ends of
the Stud Mounts (Parts B & C)
as guides, adjust the enclosure’s
horizontal position to the middle
of the wall cavity. Centering the
enclosure’s position within the
wall cavity, so that no sides of the
enclosure are in contact with the
studs, will reduce the potential for
unwanted noise and vibration.
Install two #8 x 2.00-inch pan
head screws through the guide
holes located at each end of the Stud
Mounts (Parts B & C) to set the
enclosure’s final position. Select the
guide hole locations that will place
each screw at or near the center of
each stud.
(Figure 23)
Note: As this is the last opportunity
before permanently mounting the
enclosure, we highly recommend to
double-check that the position of the
driver/grille (Wallboard Template -
Part A) is at the desired location within
the floor plan.
Figure 23
Summary of Contents for FATHOM ICS-SYS-108
